FIT OUT TWO
|
|
The hull is lined with a combination of plywood and match board The ply is used in areas that will be hidden behind units, such as cupboards etc. |
A closer view of the ply and match board. The match board was installed in the vertical orientation on the hull to provide a contrast with the cabin sides. |
The engine room was rubbed down and painstakingly hand painted in red oxide. Studs were welded on and wooden battons fitted. | A shot to show why the engine room was hand painted. It also shows the generator mounting bracket with the end of the generator in shot. |
The cabin and hull was then insulated before being lined. | The cabin sides were lined in match board and the hull will be lined in plywood. |
The boatman's cabin followed the same process as the other rooms. Rub down, painted, battons fitted and insulated. | The bulkhead dividing the engine room and boatman's cabin was insulated with 2" kingspan (to reduce noise levels). A bit of lining was also fitted. |